detail information
| Posted by | Wendy Collins |
| Posted on | 03/08/06 19:19 |
| Number of views | 10181 |
DVD-R media compatibility and write quality:
In these tests we will be using a Lite-On SHW-16H5S with firmware LS0W along with K-Probe to measure the disc quality. We will also be using the NEC ND-4570A with firmware 1.02 along with CD-Speed for our read-back tests.




Once again the amount of PIF errors are high, the result is ok but could be improved. (Thanks to SVP UK for sending us this media).




PIF errors are once again high and the read-back test shows a slight slowdown near the end of the disc. The result is ok but could be improved. (Thanks to Verbatim UK for sending us this media).




PI and PIF errors are very high and out of specification, our read-back test also displays serious issues with the write quality of this disc. A poor result and needs improving. (Thanks to medea International for sending us this media).




PIF errors are high and out of specification at the end of the disc, our read-back test also has some problems at the end of the disc. A poor result and needs improving. (Thanks to Verbatim UK for sending us this media).
DVD-ReWritable media:
We used the same testing procedures as we did for DVD-R media.
Our obtained results can be seen below.




The result is good
To sum it up: DVD-RW write quality was good with our tested media. DVD-R writing quality needs improving.
Head on to next page and read about DVD+R/-R DL compatibility and write quality...





The preview is much like a review, only shorter and less tests are carried out than a full review.
A full review will normally take us around 4 to 6 weeks to complete.
In the case of the Pioneer BDR-101A preview. The drive was only on "short term loan" to us. So a full review was not possible..


Roll on price drop.


still looking forward for more improvements though... a CD support would be a great addition, along with some faster DVD writing/reading speed...
but as a first Tech-breakthrough, this is a good step from Pioneer.. hoping to see even faster and better products soon.. and mainly.. cheaper



I'd like to buy this model but lack of lastest firmware which is VER 1.O1. If possible you can send it to me which I appreciate a lot.
Thanks in advance.
tony
tony@inhesiongroup.com


DVD+R/RW Writing performance
add a tag